The compressor was delivered with slight damage time of DHL. The assembly and start-up made no problems. The boiler is filled bar within 2 minutes to 9, corresponding to a sucked air volume of 225 liters. Decreases the pressure in the boiler by connected consumers to approximately 8 bar, the compressor starts and fills the boiler back on max. 9 bar. The compressor has been set up for the operation of a plasma torch and fulfills this task to the full satisfaction. The compressed air has a pretty good quality after passage through an oil and water separator. All fixing screws, in particular the fastening screws between the compressor and boiler should be checked at start-up and after prolonged use tightened. In addition, the compressor should be prevented from self-employed 'wandering' and if possible set up in a separate room (94 db is quite loud). The supplied, 6mm pneumatic hose is very hard and difficult to use. The compressor is recommended for small compressed air requirements.