The first impression of Ultrafit was good, a clear readable assembly instructions was present. To sew together the pipes had to be expended some strength, since the existing holes were punched and thereby probably the original shape of the tube parts has been changed. The entire pipe material has been well galvanized, but the Schweißnäte not sanded clean. This I had to expand the existing hole around the pole in the for existing lock to be able to slide on a pedestal. The hole was of course treated me with Zinc spray. After following the instructions the jumping mat was clamped, this was super easy. But now came the assembly of the trampoline network. The network bars delivered are bolted to the existing trampoline legs, However, for pre-punched holes in the trampoline frame not at the front but slightly offset (1.5cm) to the left were arranged, the legs were stamped on the front right. Thus, there was no continuous upper hole for the net rod tighten. It had all the holes on the front to be re-drilled and are treated with zinc spray. Then, after the power poles mounted ware, the network has been pulled over the network bars. Since the network was quite tight but produces, received by the power bars at the top to draw such a large endeavor inward that the legs pushed down to the outside. Naja
The best came at the end of the manual after everything was set up:
Under care and maintenance / moving the trampoline "2 people are to move the trampoline required. All joints must be a weather resistant tape, such as duct tape, wrapped and secured. This will keep the frame during movement intact and prevents move the connection points and disconnect" What ?? Tape !! The materials are high quality, the processing leaves something to be desired.