Problem while testing, commissioning of improvement

I had borrowed the repeater from a friend to try out. Only if you connect the repeater can be seen (of course) in the WLAN nothing, since this course the WLAN of my friend investigated.
In this case, it helped me just to reset the Repeater to the factory settings, then everything went quite well.
Meanwhile, I have intuitively discovered that it probably enough to re-enable WiFi menu (manually).

Additional comments:

1. In the active state of the repeater shows two LED points left (night mode)

2. When disabled, the repeater shows two LED points to the right (night mode)

The is so clearly not in the manual.

3. In the manual start-up, it is the last step ... it may take a few minutes until the connection is established ..., clearly missing here a progress bar which informs one about when the connection is ultimately. There is no further information on the part of the repeater.

I have set up the connection after about 2 minutes itself, which has not been solved so beautiful.

A few more screenshots to manually IBN and the desired progress bar at the 1st connection would be very helpful.

Even a hint that you versträrkte the WLAN later 1: 1 provides for unreinforced in the WLAN list, would be helpful.

So Doku department: publish new manual !!!