1X 433Mhz Wireless Transmitter 20-200 m

Categories

  • Works with Raspberry Pi and InterTechno  

    1X 433Mhz Wireless Transmitter 20-200 m (Misc.)
    I use this board to control a Raspberry Pi (old model) my exterior blinds on InterTechno actuators (the old with adjusting switches). You have on the board only one wire as an antenna solder (17 cm at 433 MHz) and some tinkering with the software on
    Buy at Amazon.com

  • Well delivered and it works.  

    1X 433Mhz Wireless Transmitter 20-200 m (Misc.)
    The module has, as I said, did not come late. I have tried the module and it works. I also have the module "receaver" ordered. ()
    Buy at Amazon.com

  • Recibido  

    1X 433Mhz Wireless Transmitter 20-200 m (Misc.)
    No muy rápido, pero estaba Avisado. El Paquete en buenas condiciones y parece llego funcionar. Y esto parece muy largo de redactar.
    Buy at Amazon.com

  • Good Transmittier  

    1X 433Mhz Wireless Transmitter 20-200 m (Misc.)
    After the component has been found all the way from China to me it works just fine with a Rasberry Pi. The range is (without antenna) surprisingly well (by a ceiling over 10m). Am satisfied.
    Buy at Amazon.com

  • Expires On Arduino easily  

    1X 433Mhz Wireless Transmitter 20-200 m (Misc.)
    17cm insulated leads soldered to the antenna connection, connected module on Arduino, program code (from the Internet) generated and could immediately switch my ELRO radio outlets.
    Buy at Amazon.com