Akasa AK-HDA-03 support frame for hard disks 6 4 cm in

Categories

  • especially well suited for a single drive  

    Akasa AK-HDA-03 support frame for hard disks 6.4 cm (2.5 inches) in a 8.9 cm (3.5 inch) shaft housing (accessories)
    I've got the mounting sleeve bought offline and wanted to install only one SSD. But this framework is very well suited, because the inner webs are higher than the outer - you can therefore tighten all screws without contortions. In the pack the way,
    Buy at Amazon.com

  • Good frame with small defect  

    Akasa AK-HDA-03 support frame for hard disks 6.4 cm (2.5 inches) in a 8.9 cm (3.5 inch) shaft housing (accessories)
    Basically, very valent holding frame, inexplicably, the diameter of the mounting holes is not standard of 3.5 inch HDD. Thus, it can lead to problems if one is dependent upon installation in housing on special screws and who wants to unpack the drill
    Buy at Amazon.com