Weaknesses in the door

First of all the advantages: The refrigerator has an optimum filling volume is very well laid out inside. The cooling capacity is very good, 7 degrees on the bottom floor are already using position between levels 2 and 3 (there are 5 levels) reached. I feel the unit as quiet. The description and explanation of the operation sounds with cartoons I think is very successful. In addition, the device is designed shapely.

The Disadvantages:

The defrosting is not optimal, during defrosting - the most frequently takes place - are shelves and were often shod strikingly in the refrigerator. And right after the "defrost" the back wall is the resulting steam occasionally again covered with ice!

But especially problematic is the door. In the beginning the door was always again on unnoticed if we had closed a little too peppy. The holding magnet is not very strong, which also shows the comparison with other devices, as was well saved. So springs the door at something zestful Close back - but so little that it does not really stand immediately.

Not well resolved is the setting of the standing position on the foot screws forward. They are on the one hand difficult to access, to regulate only with very flat wrenches and worked cheap. Secondly, one of the screws is mounted directly under the door frame, which programmed a gradual distortion of the door. Summit of the constructive power: the two screws (right and left) have different sizes (21 and 18)!

The reversibility of the door is relatively good, but the blowout preventers, the door handle attachment are hardly reusable. Needed a Phillips screwdriver with the shortest possible grip for a stupid screw down on the ground as well as a 7 Series and an 8mm open end wrench.

Cheap worked is also the so-called "working" area above. Since it is better to make it not much or even work towards the bend quickly.