Many criticisms I can not mention here because it is my first belt sander. But I noticed the following:
Where they will be holding it does not appreciably warm, down to the metal parts but already.
Something else I did not expect. Finally, I wanted a machine on which metal is still installed, and
not only plastic. Somewhere the 750W power must remain so, and that's just the heat ...
My criticism is the possibility of dust extraction. I have my vacuum cleaner at the designated
Nozzle plugged. The vacuum cleaner also sucks like crazy, but still the machine blows the dust across the room.
Since the designers have yet to come up with something better. Perhaps would be a safety shutdown
useful if a times but slips the heavy machine out of hand, then she runs namely simply.
Addendum:
So now the star deduction:
Previously, 4 stars, now two star deduction
The band change lever is an impertinence. It is made of plastic, although this may be useful to make you look
not soon burn their fingers, but you could have done it more stable. After intensive
Now grinding work coarse band I wanted to switch to fine grit. However, I was able to
Finger violence no longer operate the lever. I had a screwdriver as additional lever
use. Even with this aid, it was still quite difficult. Finally, I wanted this
"Filigree" levers appear also not abort. I then unscrewed times the sanding plate to me
to look at the lever construction. At the lever axis I then tried a drop of oil.
That's when plastic although suboptimal, but what was left to me. That was in fact not
especially helpful. Maybe yes also clamps the carriage that holds the tension pulley, between
a plastic guide that had narrowed by the heat and dust.
Anyway, this thing with the lever is a "no go"! Ever at a so-called professional machine.
The dust builds up in the role range is also one thing that has left a bad impression with me.
It would have been possible but a partial flow of air, which leads to the vacuum cleaner, there in the role of the field past
to lead. First then would be less dust in the room and on the grinding object, and secondly, it would be a
additional cooling.
For these reasons, I have to the purchase of this machine advise.
