With the right blade is suitable for all important materials: wood, plastic, sheet metal, aluminum, plasterboard ...
The selection of blades is huge. Not only the material to be cut determines the blade, but also whether you want to cut straight or in curves makes or rough or fine cuts. To find the right blade, helps the most qualified of the accessory finder continue on the Bosch website. Faster, although not nearly as much detail, you will find information in the Information Sheet included with the manual. By the way: SDS-saw blades from other manufacturers can be used without any problems.
Unfortunately supplied only a saw blade for soft wood panels (T144D) is included so that the question of the appropriate accessories will rise quickly.
In practice it should be noted that although in the saw blades a maximum cutting depth (the T144D eg 50 mm) is indicated, to comply with the technical specifications of the device: wood 30mm, plasterboard 24mm, 10mm plastic, aluminum 2mm. In each case the smaller values.
For my first cutting experiments with the reciprocating saw our Tuja had to serve. The conversion is quick: Remove blade with one click and click it again with the sharp side facing inwards. Even the Multisaw operates as an electric handsaw. Branches up to 3 cm I could saw through without any problems, which will also find a good lopper would have worked with leverage. However Akkusäge is here clearly manageable and convenient - if it does everything to eye level from. Otherwise, however, the cutting must Giraffe ran.
During the renovation of our greenhouse, the advantages of the Multisaw: severing of old heating pipes, cutting out old boards, cutting new shelves ... - no problem. Changing the Blades went after a short training phase thanks to the SDS system afloat by hand and the sawing results were accurate. The stroke rate via the switch works fine enough to allow a clean sawing. And in dark corners, the integrated LED light was especially helpful. Because there is no electrical outlet in our greenhouse, a battery was roomy comfort especially no annoying cables.
Since I still have another device from the 10.8 V-Family of Bosch, I could use the identical Li-ion battery to replace, while the first battery recovered at the charging station. The battery is recharged in about an hour. As with all lithium-ion batteries there is no memory effect, so that even partially discharged batteries can be recharged. How long does a battery, is very dependent on the work. A multi-stage LED (green / orange / red) are, however, information when the battery is running low.
Another price tip to all who already own a device from the 10.8 V family and therefore do not need extra battery: The Multisaw there are also considerably cheaper without battery and charger.
Overall, the work I do with the battery Multisaw fun: You work wirelessly, anywhere, the device is handy, easy to handle and the cuts are accurate. Only the manual falls with less than 10 pages and no complete "blade guide" quite poor from. Here I wish just for beginners a fuller and clearer introduction to the tool.