Wolfcraft 3754000 Hole cutter for water taps Ø 35 1 3/8 inches

Categories

  • DIY goods  

    Wolfcraft 3754000 Hole cutter for water taps Ø 35, 1 3/8 inches (tool)
    The Wolfcraft 3754000 hole cutter is DIY goods. I could now see again with a customer of this hole cutters for 5 rented in Leihcenter. The fine thread was wound up and the hole could not be completely cut. I then took my look the same punch of Brinko
    Buy at Amazon.com

  • WORK TOP  

    Wolfcraft 3754000 Hole cutter for water taps Ø 35, 1 3/8 inches (tool)
    We have drilled a hole in the sink, hole cutters pushed through and then screwed (until we had a piece of metal in his hand). Positives: - Work on with beginners Negatives: - There is a lot of power needed and it must 3x clack (the 3.x Beware BEND) I
    Buy at Amazon.com

  • Impeccable for thin sheets  

    Wolfcraft 3754000 Hole cutter for water taps Ø 35, 1 3/8 inches (tool)
    Used by me in casing and proves it as extremely useful. I punch aluminum and VA panels so. So far no problems.
    Buy at Amazon.com

  • Works 100% with built-in sink  

    Wolfcraft 3754000 Hole cutter for water taps Ø 35, 1 3/8 inches (tool)
    At first I was skeptical that the hole cutter might work. It was necessary (also from IKEA) to punch a hole with a diameter of 35 mm for fitting with a built-in sink BOHOLMEN IKEA. A small challenge is to drill the Zentrierungsloch in the size of 10m
    Buy at Amazon.com

  • The hole in it! :-)  

    Wolfcraft 3754000 Hole cutter for water taps Ø 35, 1 3/8 inches (tool)
    I bought the hole cutter to cut a hole for the faucet in the sink new. You have to pre-drill a 10mm hole, using the hole cutter and tighten with a 17 mm wrench. After a few turns then it cracks and the result is a hole with minimal burr, which can ea
    Buy at Amazon.com

  • Punches the hole clean  

    Wolfcraft 3754000 Hole cutter for water taps Ø 35, 1 3/8 inches (tool)
    Hole is clean punched by twisting. But there are a couple of carbide drills necessary to pre-drill up to 10mm. Or you buy the hole cutter with pre-drill 10.2 mm.
    Buy at Amazon.com

  • hobbyists  

    Wolfcraft 3754000 Hole cutter for water taps Ø 35, 1 3/8 inches (tool)
    absolutely outrageous in price and qualität.ich'm surprised how well you can (n) work with it, I thought using eimal and down into the bin but it was not so.ich over 50% have saved money than if I put it in a Bauhaus had bought.
    Buy at Amazon.com