Unfinished

This module, however, is still a disgrace. In my new HD + CI + certifizierten TV (Sharp 3D) it has to work 4 hours, then the module would a software update. This works but then not - both on adoption of the request, as well as via the CI menu of the TV the same result: software is not found, update fails.

Would not be so bad, just keep the old firmware on it, but I was wrong: after the module once observed that it is not the final software has denied it the service and you end up in an infinite loop.

So e-mail to HD + - encouraging rapid response but: only text modules specific enough, further questions are referred to the hotline, to 49 cents a minute - no thanks, deliver defective products and the customer is in addition to the anger even the pay debugging - not so!

Of course there are many in which works of the update, and whether it is on the module, TV, or whatever is I can not tell, but it is not my job - to lock the module finally worked the module only without problems and if HD + decides just because the update does not work they get it restrained!