I abbekam this logo by anything, I could throw away either stick or above as an alternative otherwise.
So I ordered the strap slides.
Since I already read here that unprinted areas remain white, I applied a simple trick:
My jacket is black, so I opened a Word document, and the background filled black.
Then I inserted the motive. (Self-created. Now all points outside of the subject were black as the jacket.
This I then printed out on A4, designed so that it covered the old logo.
I then ironed according to the instructions.
Probably from overcautious too short because I was first not satisfied with the result. The Black was quite spotty, sometimes bright, sometimes dark.
But it was because I had the iron not draufgehalten long enough. After repeated ironed everything was uniformly black. However, the center of the picture was from too much heat, there the subject was a bit shriveled.
But it sticks wonderful.
Note: If you have an existing label or seams under the theme, they express themselves through easily. Caution is called for.
And one must not be deceived by the expression: the expression usually looks paler than the motive behind after ironing.
One thing I have to mention. In the description was at the printer settings: Plain Paper, standard, high resolution. That does not go with my printer but. If plain paper can I choose any high resolution. Therefore I had to cheat and click a different type of paper.
My conclusion: best first time take a small motive to try out. Because the right time when the picture is perfectly ironed, you have to find first time. In addition, you can see whether color, size and texture like.
I am very happy that now I can finally put my jacket on, because the logo is inexpensive "disappeared". And that on a functional microfibre jacket!
