Ligawo ® HDMI Switch 4x1 - Pro 1080p 3D - Toslink

Categories

  • To make very good Switch to old home theater amplifier HDMI compatible  

    Ligawo ® HDMI Switch 4x1 - Pro 1080p 3D - Toslink / SPDIF - 3.5mm audio (Electronics)
    I use the 4x1 Switch with Toslink and 3.5mm jack output in order to tap the sound also from HDMI sources. Although my BluRay player has a coaxial output and can thus be connected to the amplifier, but many devices like mobile phones and tablets give
    Buy at Amazon.com

  • No automatic signal detection, tone trimmed ..  

    Ligawo ® HDMI Switch 4x1 - Pro 1080p 3D - Toslink / SPDIF - 3.5mm audio (Electronics)
    My pre / power amp combo does not have an HDMI input. In order to be embarrassed must not by any player device HDMI to your TV and TOSLINK to the receiver (which I then always have to adjust to the desired input), I needed something that derives me f
    Buy at Amazon.com

  • Finally bring digital sound with no latency for amplifiers  

    Ligawo ® HDMI Switch 4x1 - Pro 1080p 3D - Toslink / SPDIF - 3.5mm audio (Electronics)
    I wanted to essentially solve a problem: The Toslink output of my TVs are Dolby Digital signals that arrive via HDMI, only delayed again. Lip sync in movies or exact timing at Guitar Hero were therefore not possible. To connect the audio signals from
    Buy at Amazon.com

  • Super price / performance 42  

    Ligawo ® HDMI Switch 4x1 - Pro 1080p 3D - Toslink / SPDIF - 3.5mm audio (Electronics)
    Real great device for the price! 4 inputs - are> which 3 on the back and 1 on the right side (viewed from the front) On the right entrance to hang Chromecast, going from super from the square. On the left side a Toslink cable going to my Logitech
    Buy at Amazon.com

  • Works with Rasperry Pi with this tip properly  

    Ligawo ® HDMI Switch 4x1 - Pro 1080p 3D - Toslink / SPDIF - 3.5mm audio (Electronics)
    Since I do not have AV amplifier, but "only" a good audio amplifier, I needed a way to decouple the 5.1 audio signal from the Rasperry Pi-HDMI datastream. That works just fine with this device. Only necessary change: In the SD card config.txt wi
    Buy at Amazon.com